Circular connectors, also known as circular interconnects, are cylindrical multi-pin electrical connectors. These devices contain contacts for transmitting data and power. They were introduced in the 1930s for use in military aircraft manufacturing standards: A standard circular connector is usually a connector whose design conforms to German or U.S. military

When high-frequency RF connector equipment is used in the transmission path of radio, cellular, satellite and digital communications, improving the accuracy of microwave test and measurement equipment becomes more and more important.

New infrastructure may press the "fast forward" button for the development of the connector industry

The QM connector has a 2000 meter underwater push pull connectorIf the underwater cable is compared to the arms and legs of various submarine observation platforms, then the underwater connector is ju...

The mass production of each connector needs to go through the process of trial production to mass production, and trial production to mass production needs to meet certain conditions.

Radio frequency threaded connector technology began in the early stage of UHF (UHF) communication. After that, various other radio frequency connectors have been developed to meet the various needs generated by the continuous technological innovation of the communication industry. In the early 1990s, radio frequency manufacturers hoped that the interconnects of radio frequency cable assemblies could keep up with the higher power and higher voltage requirements of emerging technologies. In the radio frequency and microwave industry, there has been a development trend from threaded connectors to quick disconnect connectors with push-in, blind-mate and quick disconnect interfaces for many years.

Increase knowledge | How to make the dispensing effect of the dispenser better?The main influences on the dispensing effect of the dispenser are the size of the needle, the amount of glue, the distance between the needle and the working surface, the dispensing pressure, the viscosity of the glue, the curing temperature curve, the temperature of the glue, the bubbles in the glue, and the need Specially set fluids and so on. So, how to make the click effect of the dispenser better?